User`s manual

User’s Manual Chapter 3 Configuration Management
RV-EMS/NGN LA-210 Setting the Operational Parameters 3-11
Parameter Possible Values / Remarks
OAM (EFM)
Enables/disables IEEE 802.3ah
Enable
Disable
Default: Enable
Ingress Rate Limit Defines the rate limit
64 – 100000 kbps
Default: 25000 kbps
VLAN Tag Ether Type
Defines the VLAN TAG identifier
0 – FFFF
Default: 8100
Configuring System Parameters
LA-210 can operate in Bridge or Flow mode. You use the System menu on the
System level to choose the desired mode.
³ To view and modify Ethernet port parameters:
1. In the LA-210 View window, select the System view.
2. On the menu bar, click Configuration > System Parameters.
The System Parameters window appears.
Figure 3-7. System Parameters Dialog Box
3. Select Flows or Bridge as desired and then click Set.
The Flows or Bridge menu and associated parameters become available as
selected.
Configuring SHDSL Lines
In addition to the physical layer, you configure additional SHDSL line and PCS
(physical coding sublayer) parameters on the system level, such as the TC layer
and the wire mode.
³ To view the SHDSL parameters on the system level:
1. In the LA-210 View window, select the System view.
2. On the menu bar, click Configuration > SHDSL Lines.