User`s manual

Chapter 3 Configuration Management User’s Manual
3-10 Setting the Operational Parameters RV-EMS/NGN LA-210
Table 3-4. Ethernet Port Parameters
Parameter Possible Values / Remarks
Name The selected Ethernet port
ETH-1 – ETH-4
Read-only
Administrative Status The selected Ethernet port’s administrative status
Up,
Down
Default: Up
Auto Negotiation Enables or disables auto-negotiation
Enable
Disable
Default: Enable
Flow Control
Used to configure the default administrative PAUSE mode for this interface.
Enable
Disable
Default: Disable
Max Capability
Advertised
Specifies the set of capabilities advertised by the local autonegotiation entity.
10baseT Half Duplex
10baseT Full Duplex
100baseTX Half Duplex
100base TX Full Duplex
Default: 100BaseTX full-duplex
Note: This parameter only appears when autonegotiation is enabled.
Speed & Duplex
The static speed and duplex that the port uses when the autonegotiation is
disabled.
10baseT Half Duplex
10baseT Full Duplex
100baseTX Half Duplex
100base TX Full Duplex
Default: 100BaseTX full-duplex
Note: This parameter only appears when autonegotiation is disabled.
MDIX Auto Cross Over Enables and disables Auto Cross Over functionality.
Enable
Disable
Default: Enable
Mask Alarms Masks or unmasks alarms associated with the selected Ethernet port.
Mask
Unmask
DefaulT: Unmask