User`s manual

Chapter 3 Configuration Management User’s Manual
3-8 Setting the Operational Parameters RV-EMS/NGN LA-210
Table 3-3. SHDSL Port Parameters
Parameter Possible Values / Remarks
Port Physical port
1–2
Read-only
Note: Can be set when Mode is Unicast Client.
STU Remote
Read-only
TC Layer Operational mode
64-65 Octet
Read-only
Wires Displays the current wire mode.
2 Wire
Read-only
Administrative Status Indicates whether the link is active or not
Up
Down
Read-only
STU Remote
Read-only
Name The index of the PME (physical medium entity), displays the selected PME.
Line 1–4
Transmission Mode Annex B/G
Power Backoff[db] Temporarily reducing power while transmitting in order to prevent disturbances
due to a magnetic field (in ms).
0 (Off)
Line Probe Support for Line Probe of units associated with an SHDSL span.
Enabled
Current SNR Margin Selects the downstream/upstream current condition target SNR margin in dB. To
enable the slider, check Enable.
-10–21 db
Default: 0 (Disable)
Note: Available only when line probing is enabled.
Worst Case SNR Margin Selects the downstream/upstream worst-case target SNR margin in dB. To
configure the worst margin. To enable the slider, check Enable.
-10–21 db
Default: 0 (Disable)
Note: Available only when line probing is enabled.