User`s manual

RV-EMS/NGN LA-210 Setting the System Parameters 3-1
Chapter 3
Configuration
Management
This chapter discusses how to configure the LA-210 management system using
RADview-EMS/NGN.
This chapter describes how to configure LA-210, and explains how to perform the
following tasks:
•
Configuration Management
 Setting the System Parameters
 Viewing and Specifying Device Information
 Setting System Date and Time
• Setting the Operational Parameters
 Viewing and Configuring SHDSL Port Parameters
 Viewing and Configuring Ethernet Port Parameters
 Configuring System Parameters
 Configuring SHDSL Lines
 Configuring the Flows
 Configuring the Quality of Service
 Adding, Editing and Removing Flows
 Configuring OAM (CFM)
 Configuring Bridge Parameters
 Configuring the VLAN Membership
 Configuring MAC Tables
 Configuring QoS
 Configuring Fault Propagation
• Additional Tasks
 Resetting the Agent
 Resetting the Configuration