User`s manual

Chapter 2 Installation and Operation User’s Manual
2-14 Using the Graphical User Interface (GUI) RV-EMS/NGN LA-210
Selecting the System
Before you can perform system operations, you must first select the system in
the LA-210 View window.
The network and user ports may be selected. All other areas that are not ports
will represent the system and a frame around the panel will be displayed.
The default selection is the system.
³ To select the system:
• Click inside the LA-210 View window. Ensure that no border surrounds any of
the ports in the window.
A blue border outlines the respective LA-210 device, indicating that the
whole system is selected. (The main view includes the front and back
panels of the device.)
Figure 2-14. LA-210 System Selected in the View Window
The LA-210 application opens with a specific IP address. The NMS discovers the
device by recognizing the IP address it was designated.
Selecting Ports
Before you can perform port operations, you must first select a port in the LA-
210 View window (see
Selecting the System on page 2-12 for available LA-210
ports).
³ To select a port:
• In the LA-210 View window, click a port to select it.
A blue border outlines the selected port, indicating that it is selected.