User`s manual

User’s Manual Chapter 2 Installation and Operation
RV-EMS/NGN LA-210 Pre-configuring LA-210 for Network Management 2-5
When you allow sending general and alarm traps to a network manager, you can
mask or unmask each trap (general or interface-specific). See the following
section.
³ To add a network management station:
1. From the Management menu (Configuration > System > Management), select
Managers List.
The Managers List menu appears (see
Figure 2-3 ).
2. In the Managers list, select the IP address, which is 0.0.0.0 by default, and
then select Change Cell.
The Manager is assigned.
3. To mask or unmask a manager, select the desired manager’s Manager Trap
Mask entry and select Change Cell.
LA-210
Configuration>System>Management>Managers List
Manager ID Manager IP Manager Trap Mask
1. 0.0.0.0 Mask
2. 0.0.0.0 Unmask
3. 0.0.0.0 Unmask
4. 0.0.0.0 Unmask
5. 0.0.0.0 Unmask
6. 0.0.0.0 Unmask
7. 0.0.0.0 Unmask
8. 0.0.0.0 Unmask
9. 0.0.0.0 Unmask
10. 0.0.0.0 Unmask
1. Change Cell
A – add R – remove X – clear table
ESC-prev.menu; !-main menu; &-exit; ?-help
Figure 2-3. Manager List Menu (LA-210)