User`s manual

Installation and Operation Manual Chapter 4 Configuring a Flow-Based Point-To-Point Application
RV-EMS/NGN LA-210 Ver. 1.5 Testing the Flow Based Configuration 4-35
Figure 4-36. Bandwidth Profile for Service555 - CIR = 1 Mbps, EIR = 2 Mbps
3. For the SHDSL connection, navigate to the PCS menu (Configuration>Physical
Layer>SHDSL>PCS) and set the Egress Rate Limit to 1000 Kbps (
Figure 4-32 ).
LA-210 forwards some green packets of both Service555_pbit_7 and
Service777_pbit_4 and drops the remainder.
³ To test the new mappings:
1. Start the VLC server to transmit the movie and the client to view the result.
2. Using a serial connection, connect the server PC to ETX-202 Server and log on
to it.
3. Verify that there will be no response to pinging an ETX unit from the second
one. To do so, log on to one of the ETX-202 units, navigate to the Ping menu
(Diagnostics>Ping) and start pinging the second ETX-202 unit.
4. Following the instructions above, ping ETX-202 Server from ETX-202 Client.
5. To view the CoS statistics, navigate to Statistics > Flows Statistics > CoS – 6
and click <Statistics>.
6. View the CoS statistics for CoS3 (Statistics > Flows Statistics > CoS – 3).
Table 4-18. Statistics for Flow 1_(VLAN777-555) -
Service 777_pbit_4 and 7 (CoS 6 and CoS 3),
Upstream, CIR = 10 Mbps, EIR =2 Mbps
Fwd Green Packets 8285 Fwd Green Bytes 1114948
Fwd YellowPackets 0 Fwd Yellow Bytes 0
Dccrd Green Packet 681 Dscrd Green Bytes 92140
Dscrd Yellow Packets 0 Dscrd Yellow Bytes 0
Dscrd Red Packets 0 Dscrd Red Bytes 0
Both services, Service555_pbit_7 and Service777_pbit_4 are associated with the
same CoS, therefore the results are identical.