User`s manual

Installation and Operation Manual Chapter 4 Configuring a Flow-Based Point-To-Point Application
RV-EMS/NGN LA-210 Ver. 1.5 Testing the Flow Based Configuration 4-31
Priority Testing
This section explains how to test priority settings for two services with two
different priority bits that you configured previously, with modified priority and
with all frames transmitted at the same priority.
Using the Previously Configured Priority
This section explains how to test the priority that has been defined earlier for
Service777 and Service555.
p.bit 7 is mapped to CoS 6 and
p.bit 4 is mapped to CoS 3. CoS 3 is mapped to
queue 2
and CoS 6 is mapped to queue 4. This means that frames arriving to
queue
4 get higher priority than the frames arriving to queue 2.
³ To perform bandwidth tests on services mapped to priority bits:
1. Configure Service777_pbit_4 to CIR = 5000 Kbps and EIR = 2000 Kbps.
Figure
4-33. Bandwidth Profile for Service777 - CIR = 5 Mbps, EIR = 2 Mbps
2. Configure Service555_pbit_7 to CIR = 1000 Kbps and EIR = 2000 Kbps.