Specifications

Installation and Operation Manual Chapter 4 Configuration
LA-210 Ver. 1.5 Configuring for Operation 4-27
Configuring the Flows
This section explains how to select the flow interfaces and add packets to the
flows according to specific criteria such as the VLAN they belong to. If LA-210’s
application mode is set to Bridge, the Flows parameter does not show.
³ To set the application mode to Flows:
• From the System menu (Configuration > System), select Application and press
Enter.
The application mode is set to Flows. The Flows menu is available in the
Applications menu (Configuration > Applications).
³ To define the flow interfaces:
1. From the Flows menu (Configuration > Applications > Flows), select Flow
Interface.
The Flow Interface menu appears.
2. Specify the port where the flow starts and the flow key as detailed below.
LA-210
Configuration > Applications > Flows > Flow Interfaces
Interface ID[1 – 5] (1)
Port > (ETH-1)
1. Flow Key > (CE-VLAN ID)
2. Defaults >
ESC-Previous menu; !-Main menu; &-Exit
Figure 4-27. Flows Interfaces Screen