Specifications

Chapter 4 Configuration Installation and Operation Manual
4-26 Configuring for Operation LA-210 Ver. 1.5
LA-210
Configuration > Applications > QoS > Queue Profiles
ID (1)
Queue Default Profile (QDefaultProfile)
1. Internal Queues >
f – Forward, b - Backward
ESC-Previous menu; !-Main menu; &-Exit
Figure 4-25. Queue Profiles Screen
2. Press <F> or <B>to navigate to the desired queue profile.
3. To configure the current queue profile, select Internal Queues.
The Internal Queues menu appears as illustrated in
Figure 4-26 .
4. Configure the parameters as explained in
Table 4-10 .
LA-210
Configuration > Applications > QoS > Internal Queues
Internal Queue (1)
1. Scheduling (WFQ)
2. Weight (50)
3. Egress Rate Limit (Kbps) (100000)
ESC-Previous menu; !-Main menu; &-Exit
Figure 4-26. Internal Queues Screen
Table
4-10. Internal Queue Parameters
Parameter Function Values
Scheduling Defines the queue scheduling method.
Currently, if one of the internal queues is
configured to the WFQ mode, the queues
with the higher priority cannot be
configured to the strict mode.
Note: In configurations with Strict and WFQ
queues, the WFQ frames are transmitted
only after the transmission of frames
associated with the Strict queues is
completed.
Strict – High-priority queues that are
always serviced first. If a lower-priority
queue is being serviced and a packet
enters a higher queue, that queue is
serviced immediately.
WFQ – Weighted Fair Queuing, if one port
does not transmit, its unused bandwidth
is shared by the ‘transmitting’ queues
according to the assigned weight.
Default: Strict
Weight Determines the weight of an internal queue
when the scheduling weight is configured to
WFQ.
Note: This parameter does not show if
Scheduling is set to Strict.
1–100
Default: 50
Egress Rate Limit Defines the rate limit for all queues
together.
0 –100,000 bytes
Default: 100,000