Specifications

Chapter 4 Configuration Installation and Operation Manual
4-18 Configuring for Operation LA-210 Ver. 1.5
³ To set the application mode to Bridge:
• From the System menu (Configuration > System), select Application and press
Enter.
The application mode is set to Bridge. The Bridge menu is available in the
Applications menu (Configuration > Applications).
³ To configure the internal bridge:
• In the Bridge menu (Configuration > Applications > Bridge), configure the LA-
210 bridge. For further information, refer to
Figure 4-15 and Table 4-7 .
LA-210
Configuration > Applications > Bridge
1. VLAN Mode (Aware)
2. Forwarding Mode (Filter)
3. Aging Time (sec) [300 – 4080] … (300)
4. Static MAC Table []>
5. Bridge Port >
6. VLAN Membership >
S - Save
ESC-Previous menu; !-Main menu; &-Exit
Figure 4-15. Bridge Screen
Table
4-7. Bridge Parameters
Parameter Possible Values Remarks
VLAN Mode Aware
Unaware
Forwarding is based on MAC address only or on VLAN+MAC.
• Aware – Bridge operates according to 802.1Q
• Unaware – Operates according to 802.1D.
Default: Unaware
Forwarding
Mode
Filter
Transparent
Determines whether the bridge learns MAC addresses.
• Filter – Learning and filtering are enabled
• Transparent – No learning is performed. Each packet received is
forwarded to all other ports automatically, unless static MAC is
used.
Default: Filter
Aging Time
(sec)
300–4080 Aging time for entries in the MAC table. If the aging time elapses,
and no frame has been received from the MAC, it is erased from the
MAC table.
Default: 300 seconds