Specifications

Chapter 4 Configuration Installation and Operation Manual
4-14 Configuring for Operation LA-210 Ver. 1.5
Table 4-4. Fast Ethernet Port Configuration Parameters
Parameter Possible Values Remarks
Port 1 or 4 The Fast Ethernet port number.
Default: 1
Administrative Status Up
Down
The Fast Ethernet activation.
Default: Up
Auto Negotiation Enable
Disable
Enables or disable autonegotiation
Default: Enable
Flow Control Enable
Disable
Used to configure the default administrative PAUSE mode for
this interface.
Default: Disable
Max Capability
Advertised
10baseT Half Duplex
10baseT Full Duplex
100baseTX Half Duplex
100base TX Full Duplex
Specifies the set of capabilities advertised by the local
autonegotiation entity.
Default: 100BaseTX full-duplex
Note: This parameter only appears when autonegotiation is
enabled.
Speed & Duplex 10baseT Half Duplex
10baseT Full Duplex
100baseTX Half Duplex
100base TX Full Duplex
The static speed and duplex that the port uses when the
autonegotiation is disabled.
Default: 100BaseTX full-duplex
Note: This parameter only appears when autonegotiation is
disabled.
MDIX Auto Cross
Over
Enable
Disable
Enables and disables Auto Cross Over functionality.
Default: Enable
OAM (EFM) Enable
Disable
Enables/disables IEEE 802.3ah
Default: Enable
Ingress Rate Limit 64 – 100000 kbps Defines the rate limit
Default: 100000 kbps
VLAN Tag Ether Type 0 – FFFF Defines the VLAN TAG identifier
Default: 8100