Specifications

Installation and Operation Manual Chapter 4 Configuration
LA-210 Ver. 1.5 Configuring for Operation 4-13
Configuring Physical Layer Port Parameters
LA-210 is equipped with one or four Fast Ethernet interfaces and up to four
SHDSL interfaces. The Fast Ethernet and SHDSL physical level configuration
menus are accessed from the Physical Layer menu.
Configuring the Fast Ethernet Port
The following parameters can be configured for the Ethernet ports at the physical
level:
• Administrative status
• Autonegotiation
• Flow control
• Maximum advertised capability for autonegotiation procedure
• Data rate and duplex mode (only when autonegotiation is disabled)
• MDIX Auto cross-over.
• OAM (EFM)
• Ingress Rate Limit
• VLAN Tag Ether Type
³ To configure the Fast Ethernet port at the physical level:
1. In the Ethernet menu (Configuration > Physical Layer > Ethernet), type <F> or
<B> to select a Fast Ethernet port.
2. Set the physical layer parameters of the selected port. Refer to
Figure 4-12
and Table 4-4 for further information.
LA-210
Configuration > Physical Layer > Ethernet
Port (1)
1. Administrative Status (Up)
2. Auto Negotiation (Enable)
3. Flow Control (Disable)
4. Max Capability Advertised (100base – TX Full Duplex)
5. MDIX Auto Cross Over (Enable)
6. OAM (EFM) (Enable)
7. Ingress Rate Limit (100000)
8. VLAN Tag Ether Type (8100)
F-Forwards; B-Backwards; S-Save
ESC-Previous menu; !-Main menu; &-Exit
Figure 4-12. Ethernet Port Configuration Screen