Specifications

Installation and Operation Manual Chapter 4 Configuration
LA-210 Ver. 1.5 Configuring for Operation 4-11
Configuring Date and Time
The Date and Time menu is used to configure the NTP client parameters. The NTP
client is used as a means to receive the date and time from the network. When
the NTP server is properly configured and accessible, the device displays the real
date and time as was received from the NTP server, instead of the system
uptime, which is the default state.
³ To configure the NTP client parameters:
• In the Date and Time menu (Configuration > System > Date and Time),
configure the NTP client parameters (
Figure 4-11 and Table 4-3 ).
LA-210
Configuration > System > Date and Time
1. Date ...(0000-00-00)
2. Time ...(00:00:01)
3. NTP Mode > (Unicast Client)
4. GMT > (0)
5. NTP Server IP Address ...(172.17.163.93)
6. NTP Update Interval (sec) ...(5)
7. Send Initiated NTP Request
ESC-Previous menu; !-Main menu; &-Exit
Figure 4-11. Date and Time Menu
Table
4-3. Date and Time Configuration Parameters
Parameter Possible Values Remarks
Date Enter the date in the format <year>-<month>-<day>
Time Enter the time in the fomrat <hour>:<minutes>:<seconds>
NTP Mode Unicast Client
Disable
Unicast Client – NTP request is sent to a specific IP address
Disable – The NTP functionality is disable
Default: Disable
GMT -12 ... 12 Offset from Greenwich Mean Time
Default: 0
NTP Server IP
Address
xxx.xxx.xxx.xxx Default: 0.0.0.0
NTP Update
Interval (sec)
0 (disable)
1 ... 4294967295
Time (in seconds) between NTP requests
Default: 0 (disa`ble)
Send Initiated
NTP Request
Sends an NTP request regardless of the NTP update interval
Configuring the Application Mode
LA-210 can be set to operate in Flows or Bridge mode as explained below.
³ To specify the application mode:
1. From the Configuration menu, select System.