Specifications

Chapter 4 Configuration Installation and Operation Manual
4-6 Configuring for Management LA-210 Ver. 1.5
Configuring Radius Server Parameters
LA-210 provides connectivity to up to four Radius authentication servers.
³ To configure Radius server parameters:
1. From the Management menu (Configuration > System > Management), select
Radius Parameters.
The Radius Server menu appears as illustrated in
Figure 4-6 .
2. Specify the following parameters according to
Table 4-1 :
 Server Access. Enable or Disable
 Server IP Address. The Radius server’s IP address
 Key String. Shared secret
 Number of Retries and Timeout. Access-attempt parameters
 Authentication Port. Port used for authentication.
3. To switch to additional Radius servers, press <F> or <B> respectively.
LA-210
Configuration > System > Management > Management Access >
Radius Parameters
Server Sequence Number (1)
Server Status > (NOT_CONNECTED)
1. Server Access (Disable)
2. Server IP Address ... (0.0.0.0)
3. Key String ... ()
4. Number of Retries[0 - 10] ... (2)
5. Timeout (in seconds)[1 - 5] ... (2)
6. Authentication Port[1 - 65535] ... (1812)
Please select item <1 to 6>
F - Forward; B - Backward
ESC-prev.menu; !-main menu; &-exit
Figure 4-6. Radius Parameters
The Radius functionality requires LA-210 be connected to a Radius authentication
server maintained by a trained technician. This server should be configured in
consultation with this technician.
Note