Specifications

Chapter 3 Operation Installation and Operation Manual
3-2 Default Settings LA-210 Ver. 1.5
Table 3-1. LA-210 LEDs
Name Function
PWR (green) On: LA-210 is on
Off: LA-210 is off
TST (red) On: A test is active
Off: A test is inactive
ALM (red) On: A new alarm is detected in the alarm buffer
Off: No alarm currently detected
WAN (SHDSL SYNC 1, 2, 3, 4 - green/yellow) On (green): At least one SHDSL line is synchronized and
ready to transmit data.
Flashing (green): No SHDSL line is synchronized. At least one
SHDSL line is being initialized.
Flashing (yellow): No SHDSL line synchronized or being
initialized. At least one SHDSL line is in PAF establishment
stage.
On (yellow): No SHDSL line synchronized and no SHDSL being
initialized or in PAF establishment stage.
LAN (LINK/ACT – green/yellow) On (green): Ethernet link is up
Off: Ethernet link is down
Blinking (yellow): Data is being transferred
E1 Off: Not used
3.3 Default Settings
Table 3-2 lists the default settings of the LA-210 configuration parameters.
Table 3-2. Default System Settings
Menu Parameter Default Value
System Applixation Mode Bridge Mode
Management
Device Information Description LA-210, HW Version 0.00, SW
Version 1.50D9
Name LA-210
Location Location of the device
Contact Name of the contact person
Host IP Address 0.0.0.0
Mask 255.255.255.0
Default Gateway 0.0.0.0