Specifications

Installation and Operation Manual Chapter 2 Installation and Setup
LA-210 Ver. 1.5 Connecting to the Ethernet Equipment 2-3
2.4 Mounting the Unit
LA-210 is designed for installation as a desktop unit. It can also be mounted in a
19" rack.
• For rack mounting instructions, refer to the RM-33-2 (plastic enclosure) or
RM-35 (metal enclosure) installation kit manual.
• LA-210 can be attached to a wall using holes already drilled into the bottom
of the enclosure. A drilling template for wall attachments is included at the
end of this manual.
• If LA-210 is to be used as a desktop unit, place and secure the unit on a
stable, non-movable surface.
Refer to the clearance and temperature requirements in
Site Requirements and
Prerequisites
.
2.5 Connecting to SHDSL Equipment
LA-210 can be connected to SHDSL equipment via the single or dual RJ-45
connector, designated SHDSL. Refer to
Appendix A for the connector pinout.
CONTROL
DCE
LINK/ACT132 4
10/100BASE -T
SHDSL
12
Figure 2-1. Dual SHDSL Connector
³ To connect to the SHDSL equipment:
• Connect LA-210 to the SHDSL equipment using standard straight UTP cables
terminated with RJ-45 connectors.
2.6 Connecting to the Ethernet Equipment
LA-210 can be connected to the Ethernet user equipment via one or four 8-pin
RJ-45 electrical ports designated ETH. Refer to
Appendix A for the Ethernet
connector pinout.