Specifications

LA-210 Ver. 1.5 Configuring LA-210 1
Quick Start Guide
LA-210 should be installed by an experienced technician only. If you are familiar
with LA-210, use this guide to prepare the unit for operation.
1. Installing LA-210
Connecting the Interfaces
³ To connect the interfaces:
1. Connect the SHDSL line to the RJ-45 connector designated SHDSL.
2. Connect the user LAN to the RJ-45 connector designated 10/100BaseT (up to
four connectors).
3. Connect the control terminal to the front panel CONTROL connector.
or
Connect a Telnet host, a PC running a Web browsing application
(ConfiguRAD), or an SNMP management station to the Ethernet port.
Connecting the Power
³ To connect the power:
• Connect the power cable to the power socket on the LA-210 rear panel and
the other end to the power outlet.
The unit has no power switch. Operation starts when the power is applied to
the power connector.
2. Configuring LA-210
Configure LA-210 to the desired operation mode via an ASCII terminal connected
to the rear panel CONTROL port. After configuring, you can manage the unit over
Telnet, a PC running a Web browsing application (ConfiguRAD) or SNMP via the
Ethernet port or inband.
Remote management requires assigning a host IP address.
Note