Specifications

Installation and Operation Manual Chapter 6 Diagnostics and Troubleshooting
LA-210 Ver. 1.5 Testing the Unit 6-25
 Frame Length: Length of the frame (64–1500).
2. Select Send Ping to start sending pings.
The results appear listed in the lower scrolling message window.
3. Select Stop Ping to stop the ping test.
LA-210
Main Menu > Diagnostics > Ping
1. Destination IP Address 0.0.0.0)
2. Number of Frames to Send [0 – 50] (0)
3. Send Ping (Yes)
4. Stop Ping ()
ESC-Previous menu; !-Main menu; &-Exit; ?-Help
Figure 6-25. Ping Menu
Tracing the Route
This diagnostic utility traces the route through the network from LA-210 to the
destination host.
³ To trace a route:
• From the Trace Route menu (Diagnostics > Trace Route), perform the
following:
 Select Destination address and enter the IP address of the host to which
you intend to trace the route.
 Select Display Trace Route to start tracing.
 LA-210 starts tracing the route, displaying the IP addresses of all hop
nodes.
 Select Stop Trace Route to stop the tracing.
LA-210
Main Menu > Diagnostics > Trace Route
1. Destination address …(0.0.0.0)
2. Display Trace Route
3. Stop Trace Route
ESC-Previous menu; !-Main menu; &-Exit; ?-Help
Figure 6-26. Trace Route Menu