Specifications

Chapter 5 Configuring a Flow-Based Point-To-Point Application Installation and Operation Manual
5-4 Configuring the Units for Basic Applications LA-210 Ver. 1.5
Configuring LA-210
Operating LA-210 in flow-based operation mode requires configuring the flow
definition and specify VLANs as members of the desired flow.
Before configuring the flow definition, you should first configure the IP settings.
³ To configure the IP settings:
1. Log on to LA-210 as explained under
Accessing ETX-202 and LA-210 Units .
The Main menu appears.
2. Navigate to the Host menu and adjust the IP settings as illustrated below.
LA-210
Configuration>System
1. IP Address ... (172.17.182.23)
2. Mask ... (255.255.255.0)
3. Default Gateway ... (172.17.182.1)
4. Read Community ... (public)
5. Write Community ... (private)
6. Trap Community ... (public)
7. Encapsulation >
>
ESC-prev.menu; !-main menu; &-exit 1 M/ 1 C
Figure 5-3. Host Menu
³ To switch to the Flow mode:
1. Log on to LA-210 as explained under
Accessing ETX-202 and LA-210 Units.
The Main menu appears.
2. In the System menu (Configuration>System), under Application Mode, select
Flows Mode.
LA-210 is set to flow-based operation.
LA-210
Configuration>System
1. Management >
2. Terminal >
3. Fault Propagation >
4. Date and Time >
5. Application Mode (Flows Mode)
6. Factory Defaults
>
ESC-prev.menu; !-main menu; &-exit 1 M/ 1 C
Figure 5-4. System Menu