Specifications

Installation and Operation Manual Chapter 4 Configuration
LA-210 Ver. 1.5 Configuring for Operation 4-39
Parameter Possible Values Remarks
Default: Disabled
Continuity
Verification Mode
Disabled
LB Based
CC Based
Determines the CC behavior, visible only in RAD proprietary
mode.
Default: Disabled
Note: This parameter is available in Initiate/React OAM mode .
OAM Destination
MAC Address
Unicast Mac Address Determines the MAC address sent in OAM messages,
configurable only for Unicast MAC Address.
Default: 0120D2000100 + MD Level in RAD Proprietary,
Standard OAM MAC Address + MD Level in Standard.
CC Interval 100ms
1 sec
10 sec
1 min
10 min
Sets the CC interval between messages, read-only in RAD
proprietary mode.
Default: 1 sec
Default CC
Priority
The priority CFM messages will be sent if no service is
defined on the flow. If a service is defined, the CC will be
performed at the highest priority service on the flow.
Services Refer to Figure 4-38 and Table 4-22 , visible only in RAD
proprietary mode.
³ To configure the Services:
1. From the MEP menu (Configuration > Applications > OAM > End-To-End >
Flows > MEP), select Services.
The Services menu appears.
2. Configure the parameters as detailed below and then select Save.
LA-210
Configuration > Applications > OAM > End-To-End > Flows > MEP >
Services
Service ... (1)
1. Performance Monitoring ... (Enabled)
2. Priority ... (0)
3. Delay Objective ... (0)
4. Delay Variation Objective ... (0)
Event Reporting
5. Frame Loss Ratio >
6. Frames Above Delay >
7. Frames Above Delay Variation >
8. Unavailability Ratio >
ESC-Previous menu; !-Main menu; &-Exit
Figure 4-38. Service Menu