Specifications

IPmux-11 Installation and Operation Manual Appendix D Configuration Menus
Configuring IPmux-11 at the Physical Level D-15
Configuration>Physical layer>TDM (T1) configuration
...(P)
9. Send upon fail (OOS Code)
10. OOS code[0 - ff] ... (FF)
11. Signaling mode (Robbed Bit)
12. OOS signaling > (Space)
13. Mark signaling code[0 - f] ... (D)
14. Space signaling code[0 - f] ... (1)
>
Please select item <1 to 14>
ESC-prev.menu; !-main menu; &-exit 1 Mngr/s
Figure D-20. TDM (T1) Configuration Menu (Page 2)
Configuring Ethernet Interfaces
IPmux-11 includes one network and up to two user Ethernet ports.

To configure Ethernet interface:
1. From the Physical Layer menu (Figure D-16), select ETH Configuration.
The ETH Configuration menu appears (see Figure D-21).
2. From the ETH Configuration menu, type F to select the Ethernet interface that
you intend to configure (Network-Eth1, User1-Eth2 or User2-Eth3).
3. When the required Ethernet interface is displayed, configure the following:
 Channel state:
 Enable (Current Ethernet interface is enabled)
 Disable (Current Ethernet interface is disabled)
 Auto negotiation:
 Enable (Autonegotiation is enabled)
 Disable (Autonegotiation is disabled)
 Max capability advertised (Maximum capability to be advertised during the
autonegotiation process):
 10BaseT Half Duplex
 10BaseT Full Duplex
 100BaseT Half Duplex
 100BaseT Full Duplex
 Default type (Rate and duplex mode, if the autonegotiation is disabled)
 10BaseT Half Duplex
 10BaseT Full Duplex
 100BaseT Half Duplex
 100BaseT Full Duplex