Specifications

Appendix D Configuration Menus IPmux-11 Installation and Operation Manual
D-12 Configuring IPmux-11 at the Physical Level
4. If you configure the Line type to Framed MF or Framed MF CRC4, type N to
display the next page of E1 parameters (Figure D-18):
 Send Upon Fail (Notification sent to the E1 side if Ethernet link fails):
 OOS Code (Out-of-service code)
 AIS (alarm indication signal)
 OOS code (Code to be sent to the E1 side if Ethernet link fails): 0–ff
 OOS signaling (Out-of-service signaling method. OOS signal is sent toward
the IP path when loss of signal, loss of frame, or AIS is detected at the E1
line. The OOS signal is also sent toward the E1 line when packet receive
buffer overrun or underrun occur.):
 Space (code specified by the Space Signaling Code parameter is sent)
 Mark (code specified by the Mark Signaling Code parameter is sent)
 Space Mark (space code is sent in the first 2.5 seconds, then mark code
is sent)
 Mark Space (mark code is sent in the first 2.5 seconds, then space code
is sent)
 Mark Signaling Code: 0–f
 Space Signaling Code: 0–f
5. Type S to save the changes.
Configuration>Physical layer
1. TDM Configuration >
2. ETH Configuration >
>
Please select item <1 to 2>
ESC-prev.menu; !-main menu; &-exit 1 Mngr/s
Figure D-16. Physical Layer Menu