Specifications

IPmux-11 Installation and Operation Manual Appendix D Configuration Menus
Configuring IPmux-11 at the Physical Level D-11
D.4 Configuring IPmux-11 at the Physical Level
The TDM (E1 or T1) and Ethernet interfaces of IPmux-11 must be configured at
the physical level.
Configuring the E1 TDM Interface
The E1 and T1 interfaces of IPmux-11 is configured via the TDM Configuration
menu. IPmux-11 automatically detects whether the interface is E1 or T1, and
displays the appropriate menu.

To configure the E1 interface:
1. From the Configuration menu (Figure D-4), select Physical layer.
The Physical Layer menu appears (see Figure D-16).
2. From the Physical Layer menu, select TDM configuration.
The TDM (E1) Configuration menu appears (see Figure D-17).
3. From the TDM (E1) Configuration menu, configure the following:
 Admin Status:
 Enable (E1 link is enabled)
 Disable (E1 link is disabled)
 Transmit clock source:
 Adaptive (adaptive clock regeneration)
 Loopback (E1 recovered Rx clock is used as the Tx clock)
 Internal (Tx clock is received from an internal oscillator)
 External (Tx clock is received from the external clock input)
 Rx sensitivity (Maximum attenuation of the receive signal that can be
compensated for by the interface receive path):
 Short haul (-10 dB)
 Long haul (-32 dB)
 Line type (E1 framing mode):
 Unframed G.703 (Framing is not used)
 Framed G.704 (G.704 framing, CRC-4 function disabled)
 Framed G.704 CRC4 (G.704 framing, CRC-4 function enabled)
 Framed MF (CAS enabled, CRC-4 function disabled)
 Framed MF CRC4 (CAS enabled, CRC-4 function enabled).
 Idle Code (code transmitted to fill unused timeslots in the E1 frames):
00 to ff.