Specifications

Appendix D Configuration Menus IPmux-11 Installation and Operation Manual
D-6 Configuring System Parameters
2. From the Authentication/Community menu, do the following:
 Select Authentication failure trap to enable or disable sending this trap in
case of an unauthorized access attempt.
 Select Trap to enter the name of a community to which
IPmux-11 will send traps (up to 10 alphanumeric characters, case-sensitive).
 Select Read to enter the name of a community with read-only
authorization (up to 10 alphanumeric characters, case-sensitive).
 Select Write to enter the name of a community with write authorization
(up to 10 alphanumeric characters, case-sensitive).
Configuration>System>Management>Authentication/community
1. Authentication Failure Trap (Disable)
2. Trap ... (SNMP_trap)
3. Read ... (public)
4. Write ... (private)
>
Please select item <1 to 4>
ESC-prev.menu; !-main menu; &-exit 1 Mngr/s
Figure D-9. Authentication/Community Menu
Defining Network Managers
Define or modify the network management stations to which the SNMP agent of
IPmux-11 will send traps. Up to 16 managers can be defined. In addition, you can
enable or disable manager stations to receive traps.

To define network managers:
1. From the Management Access menu (see Figure D-5), select Manager list.
The Manager List menu appears (see Figure D-9).
2. From the Manager List menu, perform the following:
 Select Manager IP address, and enter an IP address of the manager station.
 Select Manager location, and from the Manager Location menu, choose
the IPmux-11 port to which the current management station is connected
(Network-Eth1 – network Ethernet port, User1-Eth2 – user Ethernet port 1,
User2-Eth3 – user Ethernet port 2, or All if the management station
location is not relevant).
 Select Link up/down trap, and choose On to enable the management
station to receive a trap, when a link failure (link down) or link recovery
(link up) occurs. Choose Off to disable Link Up/Down trap receipt.