Specifications

Chapter 3 Operation IPmux-11 Installation and Operation Manual
3-8 Default Settings
Table 3-2. Default Settings (Cont.)
Parameter Default Value
Physical Layer (TDM, E1)
Admin status Enable
Transmit clock source Adaptive
Loopback state Disable
Rx sensitivity Short haul
Line type Framed G.704
Idle code 7E
Send upon fail OOS code
OOS code FF
OOS signaling Space
Mark signaling code D
Space signaling code 1
Physical Layer (TDM, T1)
Admin status Enable
Transmit clock source Adaptive
Line type ESF
Line code B8ZS
Line interface DSU
Line length 0–133
Restoration time TR-6211 (10 seconds)
Idle code 7E
Send upon fail OOS code
OOS code FF
Signaling mode None
OOS signaling Space
Mark signaling code D
Space signaling code 1
Physical Layer (ETH)
Channel state Enable
Auto negotiation
• Disable for fiber optic interface
• Enable for copper interface
Max capability advertised 100baseT full duplex
Default type 10baseT half duplex