Specifications
IPmux-11 Installation and Operation Manual Chapter 3 Operation
Overview of Menu Operations 3-5
3.4 Overview of Menu Operations
Use these menu trees as a reference aid while performing configuration and
control functions. Appendix D illustrates menus and explains parameters. Table 3-2
lists default values.
Main Menu
SystemConfiguration
Host IP
Management
User Access
Control Port
1. Inventory
2. Configuration
3. Monitoring
4. Diagnostics
5. Utilities
1. Host IP
2. Management
3. Control port
4. Date/time
5. Factory default
1. System
2. Physical Layer
3. Connection
4. Bridge
1. IP address
2. IP mask
3. Default gateway
4. DHCP
1. Device info
2. Authentication/community
3. Manager list
4. Manager access
5. Alarm trap mask
1. User name
2. Permission
3. Access
4. Old password
5. New password
6. Confirmation
Baud rate
Data bits
Parity
Stop bits
Flow control
Date/Time
Authentication/Community
1. Set time
2. Set date
1. System name
2. System location
1. Authentication failure trap
2. Trap
3. Read
4. Write
Manager List
Management Access
Alarm Traps Mask
1. Manager IP address
2. Manager location
3. Link up/down trap
4. Alarm trap
5. VLAN tagging
6. VLAN ID
7. VLAN priority
1. User access
2. Telnet access
3. Web access
1. Alarm ID [1-40]
2. Trap status
Device Info
Figure 3-2. Main Menu > Configuration > System
Configuration Physical Layer TDM Configuration (E1)
Or
Tdm Configuration (T1)
ETH Configuration
1. System
2. Physical layer
3. Connection
4. Bridge
1. TDM configuration
2. ETH configuration
1. Admin status
2. Transmit clock source
3. Rx sensitivity
4. Line type
5. Idle code [0 - ff]
6. Send upon fail
7. OOS code [0 - ff]
8. OOS signaling
9. Mark signaling code [0-f]
10. Space signaling code [0-f]
1. Admin status
2. Transmit clock source
3. Line type
4. Line code
5. Line interface
6. Line length (feet)
7. Restoration time
8. Idle code [0 - ff]
9. Send upon fail
10. OOS code [0 - ff]
11. Signaling mode
12. OOS signaling
13. Mark signaling code [0-f]
14. Space signaling code [0-f]
1. Channel state
2. Auto negotiation
3. Max capability advertised
4. Default type
Figure 3-3. Configuration > Physical Layer > TDM and ETH Configuration