Specifications

IPmux-11 Installation and Operation Manual Appendix D Configuration Menus
Configuring Ethernet Bridge D-19
D.6 Configuring Ethernet Bridge
IPmux-11 contains an internal bridge where one of its ports is connected to a
TDMoIP interworking function, two external bridge ports is used as the user ports,
and the fourth is used as an Ethernet network port.

To configure Ethernet bridge:
1. From the Configuration menu (Figure D-4), select Bridge.
The Bridge menu appears (Figure D-25).
2. From the Bridge menu, select Aging time and define a period of time in
seconds from the moment when a node is disconnected from the network
segment or becomes inactive and removal of the node address from the
database.
3. Select Erase MAC table, if you intend to delete all learned addresses from the
MAC table.
4. Select Bridge policy configuration, and from the Bridge Policy Configuration
menu (Figure D-26) define the following:
 VLAN tagging (operation mode for the corresponding port of internal
switch. Refer to Ethernet Ports in Chapter 1 for detailed explanation):
 Transparent
 Tag (Tagged)
 Untag (Untagged)
 DoubleTag (Double Tagged)
 Default VLAN ID (VLAN associated with untagged frames arriving at the
port): 1–4095
 Default VLAN Priority: 0–7
 Rate limit:
 Network port: Disable, 128 kbps, 256 kbps, 512 kbps, 1 Mbps,
2 Mbps, 4 Mbps, 8 Mbps
 Network port: Disable, 128 kbps, 256 kbps, 512 kbps, 1 Mbps,
2 Mbps, 4 Mbps, 8 Mbps, 16 Mbps, 32 Mbps, 64 Mbps
5. Select VLAN table configuration, and from the VLAN Table Configuration
menu (Figure D-27) configure the following:
 Channel:
 Network-Eth1
 User1-Eth2
 User2-Eth3
 VLAN ID (Selects the VLAN to edit. Creates a VLAN entry if the VLAN does
not exist): 1–4095