Specifications

IPmux-11 Installation and Operation Manual Appendix D Configuration Menus
Configuring Bundle Connections D-17
6. From the Bundle Connection Configuration menu, configure the following:
 IP TOS (IP ToS field in the IP frames transmitted by IPmux-11. ToS
configuration configures the WHOLE byte, since different vendors may use
different bits to tag packets for traffic prioritization. ToS assignment applies
to all TDM packets leaving IPmux-11.): 0–255.
 TDM Bytes in Frame (x48 bytes) (UDP payload length – this parameter
enables reduction of Ethernet throughput): 1–30
 Connection Status:
 Enable (connection is enabled)
 Disable (no frames are sent from this connection)
 Destination IP Address (IP address of the destination device): 0.0.0.0 to
255.255.255.255.
 Next Hop (Use the next hop parameter when the destination IP address is
not in the device subnet. In such cases the Ethernet frame is sent to the
next hop IP. If it is not configured, the default gateway is used.): 0.0.0.0 to
255.255.255.255.
 Destination bundle (bundle number in the destination device): 1–2000.
 Jitter buffer (desired depth of the jitter (PDVT) buffer): 3–300 msec
 OAM connectivity:
 Enable (The device starts transmitting at full rate after it detects an
active, properly configured, the unit on the other side of the line.)
 Disable (OAM connectivity is disabled)
 Payload Format (TDMoIP format):
 Old format
 VLAN Tagging:
 Enable (VLAN tagging is enabled)
 Disable (VLAN tagging is disabled)
 VLAN ID: 1–4095
 VLAN priority: 0–7
Make sure that selected VLAN is configured as a member of the network port VLANs
(see Configuring Ethernet Bridge below).
7. Type S to save the changes.
Note