Specifications

Appendix D Configuration Menus IPmux-11 Installation and Operation Manual
D-16 Configuring Bundle Connections
When autonegotiation protocols do not support each other, this will degrade the
connection to a half-duplex mode. In order to avoid this, autonegotiation should be
disabled and the ports should be configured manually. Half-duplex degradation will
occur also when autonegotiation is enabled at one port and disabled at the
opposite port.
4. Type S to save your changes.
Configuration>Physical layer>ETH configuration
Channel > (Network-Eth1)
1. Channel state (Enable)
2. Auto negotiation (Disable)
3. Max capability advertised > (100baseT Full Duplex)
4. Default type > (100baseT Full Duplex)
>
Please select item <1 to 4>
F – Forward
ESC-prev.menu; !-main menu; &-exit 1 Mngr/s
Figure D-21. ETH Configuration Menu
D.5 Configuring Bundle Connections
IPmux-11 supports one bundle that can include up to 31 E1 or up to 24 T1
timeslots. The bundle can be connected to any bundle of the TDMoIP device that
operates opposite IPmux-11. Currently, TDMoIP traffic is sent and received via the
network port only.

To configure bundle connection:
1. From the Configuration menu (Figure D-4), select Connection.
The Connection menu appears (see Figure D-22).
2. From the Connection menu, select Bundle, and select
3. Select DS0 bundle configuration.
The DS0 Bundle Configuration menu appears (see Figure D-23).
4. From the DS0 Bundle Configuration, assign timeslots to the current bundle by
selecting a timeslot and choosing 1 (assigned) or 0 (not assigned).
5. From the Connection menu, select Bundle connection configuration.
The Bundle Connection Configuration menu appears (see Figure D-24).
Not
e