Specifications

Installation and Operation Manual Chapter 4 Configuration

IPmux-8/16 Ver. 6.00 Configuring IPmux-8/16 for Operation 4-27

• System Usage – Percentage of the Ethernet uplink that is being currently used.

This information is provided for each Ethernet uplink.

For channelized T3 interfaces, when the system usage reaches 100%, the unit does

allow adding another bundle on the current Ethernet uplink.

• Bundle Throughput – Bandwidth used by the current bundle

• Total Throughput – Bandwidth used by all bundles

BUNDLE CONNECTION CONFIGURATION

1. DS0 Bundle ID 194

2. Connection Status Enable

3. Destination IP Address 0.0.0.0

4. Next Hop 0.0.0.0

5. Destination Bundle 249

6. Jitter Buffer (x10 usec) 300

7. TDM bytes in frame (x48 bytes) Empty!

8. OAM Connectivity Disable

9. Redundancy Function None

A. VLAN ID 10

B. VLAN Priority 00

C. Protocol Version V2

ESC. Exit N. Next

SYSTEM USAGE BUNDLE THROUGHPUT[BPS] TOTAL THROUGHPUT[BPS]

LAN 1: Not Applicable 0.0 46600

LAN 2: 12.00% 46600 497321

Select item from the menu.

Figure 4-15. Bundle Connection Configuration Menu

Configuring Internal Cross Connect

IPmux-8/16 allows connect bundles from the same unit internally.



To connect bundles internally:

1. Define two bundles (for example 1 and 2).

2. Set the host IP address as destination IP address for both bundles.

3. For bundle 1, set bundle 2 as destination bundle.

IPmux-8/16 automatically sets bundle 1 as destination bundle for bundle 2.

No configuration parameters can be changed for cross-connected bundles. To

reconfigure parameters, delete the bundles and define them anew.

Note