Specifications

Chapter 4 Configuration Installation and Operation Manual

4-26 Configuring IPmux-8/16 for Operation IPmux-8/16 Ver. 6.00

 Next Hop (Use the next hop parameter when the destination IP address is

not in the device subnet. In such cases the Ethernet frame is sent to the

next hop IP. If it is not configured, the default next hop IP address is used. If

the default hop IP address is not defined, IPmux-8/16 uses the default

gateway IP address.)

 0.0.0.0 to 255.255.255.255.

 Destination bundle (bundle number in the destination device)

 1–2000.

 Jitter buffer (desired depth of the jitter (PDVT) buffer in × 10 microseconds)

 E1: 50–3200 (0.5 msec to 32 msec)

 T1: 50–2400 (0.5 msec to 24 msec)

 E3: 300–2900 (3 msec to 29 msec)

 T3: 300–2900 (3 msec to 29 msec)

 CT3: 50–4200 (0.5 msec to 42 msec)

 TDM Bytes in Frame (x48 bytes) (UDP payload length – this parameter

controls Ethernet throughput): 1–30

 OAM Connectivity

 Enable (The device starts transmitting at full rate after it detects an active,

properly configured unit on the other side of the line.)

 Disable (OAM connectivity is disabled)

 Redundancy Function (Determines the bundle redundancy functionality):

 Disable (The bundle is not part of protected switching configuration)

 Primary (The bundle is set as the main bundle. At startup it is selected by

IPmux-8/16 as the active bundle.)

 Secondary (The bundle is set as the backup bundle. At startup it is

selected by IPmux-8/16 as the offline bundle.)

 VLAN ID: 1–4095

 VLAN priority: 0–7

VLAN parameters are available only if the VLAN tagging is enabled for the current

module in the Host Configuration menu (

Figure 4-2).

 Protocol Version (TDMoIP format):

 V1 (Old format)

 V2 (New format, as per ietf-pwe3-tdmoip)

TDMoIP format configuration is not available for E3 and T3 interfaces.

The Bundle Connection Configuration menu also contains several additional

information parameters:

Note