Specifications

Installation and Operation Manual Chapter 4 Configuration
IPmux-8/16 Ver. 6.00 Configuring IPmux-8/16 for Operation 4-19
Configuring E3 or T3 Interface
IPmux-16 supports up to two E3 or T3 links. Each E3 or T3 interface must be
configured individually.
Path: Main > Configuration > Physical Layer Configuration > Slot # 3/4.

To configure E3 or T3 interface:
1. Follow the path above to access the E3/T3 Physical Layer Configuration menu
(
Figure 4-11).
2. From the E3/T3 Physical Layer Configuration menu, configure the following:
 Channel Status
 Enable (E3/T3 link is enabled)
 Disable (E3/T3 link is disabled)
 Transmit Clock Source
 Adaptive (Adaptive clock regeneration)
 Loopback (E3/T3 recovered Rx clock is used as the Tx clock)
 Internal (Tx clock is received from an internal oscillator)
 Loopback State (Controls activation of diagnostic loopbacks, see Diagnostic
Loopbacks in Chapter 6 for detailed loopback function explanation)
 Internal (Internal loopback is activated)
 External (External loopback is activated)
 Disable (All loopbacks are deactivated)
E3/T3 PHYSICAL LAYER CONFIGURATION
1. Channel Status Enable
2. Transmit Clock Source Loopback
3. Loopback State Disable
ESC. Exit
Current Slot 3
Select item from the menu.
Figure 4-11. E3/T3 Physical Layer Configuration Menu
Configuring Channelized T3 Interface
IPmux-16 supports up to two channelized T3 links. Each channelized T3 interface
consists of external T3 layer and 28 unframed T1 channels. The external T3 and
each T1 channel have to be configured individually.