Specifications

Chapter 4 Configuration Installation and Operation Manual
4-18 Configuring IPmux-8/16 for Operation IPmux-8/16 Ver. 6.00
 Cond. CAS (AB/ABCD) Pattern (2- or 4-bit code applied to AB (D4) or
ABCD (ESF) bits when a fault condition occurs. The ABCD conditioning
pattern transferred in CAS toward the IP path when loss of signal, loss of
frame or AIS is detected at the T1 line. Conditioning data pattern is also
applied to CAS sent toward the T1 line when packet receive buffer overrun
or underrun occurs.): 1–F.
 Cond. CAS First 2.5 sec. Pattern (2-or 4-bit code applied (during the first
2.5 seconds) to AB (D4) or ABCD (ESF) bits (relevant in CAS mode only)
when fault conditions occur. After the first 2.5 seconds the code specified
in ‘Cond. CAS (AB/ABCD) pattern’ is applied. AB/ABCD conditioning
pattern is sent toward the IP path when loss of signal, loss of frame or AIS
detected at the T1 line. Conditioning pattern can be sent applied toward
the T1 line when packet receive buffer overrun or underrun occurs. When
configured to FF, this parameter is ignored.)
 0–F (ESF).
 0–3 (D4)
 FF.
T1 PHYSICAL LAYER CONFIGURATION
1. Channel Status Enable
2. Transmit Clock Source Loopback
3. Loopback Configuration >
4. Line Type T1-ESF
5. Line Code B8ZS
6. Line Mode DSU
7. Line Length(feet)/Tx Gain(dB) 0-133
8. UpLink Fail Alarm Behavior Cond.
9. Restore Time 1 second
A. Idle Code 7E
B. Signaling Mode CAS enable
C. Leased Line Disable
E. Cond. Data Pattern FF
F. Cond. CAS (AB/ABCD) Pattern 01
G. Cond. CAS first 2.5sec pattern(FF=NULL) FF
ESC. Exit
Current Slot/Channel is 4 /1
Select item from the menu.
Figure 4-10. T1 Physical Layer Configuration Menu