Specifications

Chapter 4 Configuration Installation and Operation Manual
4-4 Configuring IPmux-8/16 for Management IPmux-8/16 Ver. 6.00
3. Type Y to confirm.
A second confirmation message is displayed: Bundle connections,
Default GW and Managers IP will be deleted (Y/N).
4. Type Y to confirm.
The host is deleted.
Deletion of host ID automatically deletes the following parameters: host IP,
default gateway, all managers and all bundles connected to the host.
Defining Network Managers
Define network managers, which access IPmux-8/16 via its Ethernet ports. The
management access can be ether out-of-band (via CONTROL ETH port) or inband
via LAN ports of the Ethernet modules. Each manager must be assigned to a
specific host (out-of-band, Ethernet 1 or Ethernet 2). Up to eight network
managers can be added. Also, you can enable or disable manager stations to
receive certain traps sent out by IPmux-8/16 in case of malfunction.
Path: Main > Configuration > General Configuration > Management
Configuration > Manager List.

To define a network manager:
1. Follow the path above to access the Manager List menu (
Figure 4-3).
2. From the Manager List menu, configure the following:
 Manager IP Address (IP address of the management station)
 Host index (index of the host, which the management station is assigned to)
 OOB Management Host (host for out-of-band management traffic via
CONTROL ETH port)
 Ethernet 1 Host (Host of the network port of the Ethernet module
installed in slot 1. This host serves for the TDMoIP traffic and inband
management)
 Ethernet 2 Host (Host of the network port of the Ethernet module
installed in slot 2. This host serves for the TDMoIP traffic and inband
management)
 Manager Location (Relevant only for 4-port Ethernet modules. Specifies
which internal switch ports are allowed to handle management traffic
coming from the current manager station)
 Network Port Only (only network port is allowed to handle the
management traffic)
 User Port1 Only (Only user port 1 is allowed to handle the management
traffic)
 User Port2 Only (Only user port 2 is allowed to handle the management
traffic)
Warning