Specifications

Chapter 4 Configuration Installation and Operation Manual
4-2 Configuring IPmux-8/16 for Management IPmux-8/16 Ver. 6.00
 Select Write to enter the name of a community with write authorization
(up to 10 alphanumeric characters, case-sensitive).
AUTHENTICATION/COMMUNITY
1. Authentication Failure Trap Off
2. Trap public
3. Read public
4. Write public
ESC. Exit
Select item from the menu: _
Figure 4-1. Authentication/Community Menu
Configuring Host IP Parameters
IPmux-8/16 hosts must be assigned an IP address and IP mask to allow
communication between the local and remote IPmux units. Valid IP addresses are
also needed for the inband and out-of-band management of the unit. IPmux-8/16
supports separate hosts for out-of-band management (OOB Management Host)
and two Ethernet module hosts (Ethernet 1 Host and Ethernet 2 Host). The
out-of-band management host IP address should be on a different subnet than the
Ethernet 1 and Ethernet 2 host IP addresses.
IPmux-8 does not support out-of-band management host.
Path: Main > Configuration > General Configuration > Management
Configuration > Host Configuration.

To configure host IP parameters:
1. Follow the path above to display the Host Configuration menu (
Figure 4-2).
2. From the Host Configuration menu, configure the following:
 Host Index (Host identification index)
 OOB Management Host (Host for out-of-band management traffic via
CONTROL ETH port)
 Ethernet 1 Host IP (Network port host of the Ethernet module installed
in slot 1. This host serves for both TDMoIP traffic and inband
management)
 Ethernet 2 Host (Network port host of the Ethernet module installed in
slot 2. This host serves for both TDMoIP traffic and inband management)
 IP Address
 IP Mask
Note