Specifications

Installation and Operation Manual Chapter 3 Operation
IPmux-8/16 Ver. 6.00 Default Settings 3-5
Table 3-4. Default Settings (Cont.)
Type Parameter Default Value
PHYSICAL LAYER CONFIGURATION
E1
Channel Status Enable
Transmit Clock Source Loopback
Loopback State Disable
Rx Sensitivity -10 dB
Line Type CRC4 Enabled
UpLink fail Alarm Behavior Cond.
Idle Code 7E
Signaling Mode CAS enable
Cond. Data pattern 7F
Cond. CAS (ABCD) Pattern 01
T1
Channel Status Enable
Transmit Clock Source Loopback
Line Type T1-ESF
Line Code B8ZS
Line Mode DSU
Line Length(feet)/Tx Gain 0-133/ -7.5 dB
UpLink fail Alarm Behavior Cond.
Restore Time 1 second
Idle Code 7E
Signaling Mode CAS enable
Leased Line Disable
Cond. Data pattern 7F
Cond. CAS (AB/ABCD)
Pattern
01
Cond. CAS first 2.5sec
Pattern
FF
Loopback State Disable
Loopback Location Local System
Activate Loop Pattern 10000
Deactivate Loop Pattern 100
E3, T3
Channel Status Enable
Transmit Clock Source Loopback
Loopback State Disable