Specifications

Chapter 3 Operation Installation and Operation Manual
3-4 Default Settings IPmux-8/16 Ver. 6.00
Table 3-3. IPmux-16 Interface/Rear Panel Indicators and Switches
Module Name Type Function
Ethernet
(user)
LINK LED
(yellow)
ON: LAN is connected
OFF: LAN is disconnected
ACT LED
(green)
ON: Frame being transferred on line
OFF: No activity
E1/T1
SYNC LED
(green)
ON: Port synchronized (no alarm)
OFF: Unframed – Signal loss or AIS detected
Framed – Signal loss, loss of frame or
AIS detected
Blinking: RDI detected (remote alarm)
E3/T3 SYNC ON: Port synchronized (signal detected)
OFF: Signal loss or AIS detected
CT3 SYNC ON: Port synchronized (signal detected)
OFF: Signal loss or AIS detected
Rear panel PS1/PS2 Switch Turns IPmux-16 power on and off
3.3 Default Settings
Table 3-4 lists the default settings of the IPmux-8/16 configuration parameters.
Table 3-4. Default Settings
Type Parameter Default Value
SYSTEM
Telnet Access Enable
SNMP Access Enable
Authentication/Community
Authentication failure trap Off
Trap public
Read public
Write public
Host Configuration
Host Index OOB Management Host
Manager List
Manager IP Address 0.0.0.0
Host Index Ethernet 1 Host
Default Gateway
Gateway IP 0.0.0.0
ASCII Terminal Configuration
Display Mode Color
Baud Rate 19200
15 min. Timeout On
Hard flow ctrl (RTS/CTS) Off