Specifications

Installation and Operation Manual Chapter 3 Operation
IPmux-8/16 Ver. 6.00 Front Panel Controls, Connectors, and Indicators 3-3
PS1
RX
TX
LINK
COLL
IPmux-16
ALM
CONTROL ETH
PS2 RDY
CONTROL DTE
Figure 3-3. IPmux-16 Front Panel
PS1
~100 -24 0VAC 3A T 125V
POWER
O
I
~100-240VAC 3A T 125V
POWER
O
I
PS2PS1
CH1
CH5
CH2
CH6
CH3
CH7
CH4
CH8
CH1
CH5
CH2
CH6
CH3
CH7
CH4
CH8
8E1 8E1
1 1
5 5
3 3
7 7
2 2
6 6
SYNC SYNC
4 4
8 8
ETH/SFP
ACTACT ACTLINKLINK LI NK1324
ETH/UTP/4
ACT ACTACT ACTLINK LINKLI NK LINK1324
Figure 3-4. IPmux-16 Rear Panel Switch (2
× 8-Port E1 Modules, 2 × 4-Port Ethernet Modules)
Table 3-2 lists the functions of the IPmux-16 system indicators.
Table 3-2. IPmux-16 Front Panel Indicators and Switches
Module Name Type Function
RDY LED
(green)
ON: Device is OK
OFF: Self-test in progress
Blinking: Malfunction detected
PS1/PS2 LED
(green)
ON: Unit powered
OFF: Unit not powered
System
ALM LED
(red)
ON: Alarm is stored in the log file
OFF: No alarm is stored in the log file
LINK LED
(yellow)
ON: LAN is connected
OFF: LAN is disconnected
Ethernet
(MNG)
COLL LED
(yellow)
ON: Collision is detected on the Ethernet
interface (half duplex mode only)
OFF: No collision is detected on the Ethernet
interface
TX LED
(yellow)
ON: Data is being transmitted on the Ethernet
interface
OFF: No data is being transmitted on the
Ethernet interface
RX LED
(yellow)
ON: Data is being received on the Ethernet
interface
OFF: No data is being received on the Ethernet
interface