Specifications

Chapter 2 Installation and Setup Installation and Operation Manual
2-10 Connecting IPmux-8/16 to Power IPmux-8/16 Ver. 6.00
8. Connect IPmux-8/16 to the mains.
9. Turn the power supply switch on. The switch red cover lights up.
10. Turn the power supply switch off.
11. AC power supply: Insert the cable safety lock.
DC power supply: Lock the DC connector by inserting the two locking cable
screws into the hex nuts on the power supply panel.
12. Verify the power supply is secured in its slot.
If IPmux-8/16 has a single AC power supply unit, install the safety lock support first
at the proper power supply slot. The safety lock support consists of one banded
part attached to the protection panel with screws. In this case, the cable safety lock
is already installed in the support.
Note