Specifications

Installation and Operation Manual Chapter 1 Introduction
IPmux-8/16 Ver. 6.00 Technical Specifications 1-29
Jitter Performance
Jitter tolerance: GR-499 (CAT II), G.824, TR 54014
Jitter transfer: G.755, GR-499 (CAT II), TR 54014
Intrinsic jitter: G.755, GR-253, TR 54014
Output jitter: GR-499 input jitter attenuated to the levels
of a T1.404 network interface for CI type I equipment
Max. Average
Reframe Time
To a DS3: less than 1.5 ms
To a DS2: less than 7 ms
Framing Formats
M23 and C-bit parity DS3
Ethernet
Modules
Number of Ports
1-port Ethernet module: 1 per module (network)
4-port Ethernet module: 4 per module (1 network and
3 user ports), via SFP (up to 2 fiber optic ports per
module)
Compliance
IEEE 802.3, 802.3u, 802.1p&Q
Maximum Frame Size
1536 bytes
Note: Maximum frame size of the management traffic
(ICMP, SNMP etc) is 1532 bytes.
Connector
RJ-45, 8 pin
Data Rate
10 Mbps or 100 Mbps, full or half-duplex
Fiber Optic
Characteristics: see Table 1-12, Table 1-13
Connector: LC
Terminal
Control Port
Interface
RS-232 (V.24), DTE
Baud Rate
9.6, 19.2, 38.4, 57.6, 115.2 kbps
Connector
9-pin, D-type, male
Compliance
IEEE 802.3, 802.34
Connector
RJ-45, 8-pin
Management
Ethernet Port
Data Rate
10 Mbps full/half-duplex
Contacts
30V 2A
Alarm Relay
Connector
9-pin, D-type, female
General
System
Indicators
PS1
ON (green): PS1 OK
ON (red): PS1 failed
OFF: PS1 is absent
PS2
ON (green): PS2 OK
ON (red): PS2 failed
OFF: PS2 is absent
RDY
On: Normal operation
OFF: During initialization phase