Specifications

Installation and Operation Manual Chapter 1 Introduction
IPmux-8/16 Ver. 6.00 Overview 1-3
Figure 1-3. IPmux Devices Managed by RADview Network Management System
Features
E1/T1 frames or DS0 bundles are transported over the network based on IP
addressing. E3/T3/CT3 ports and framers are available for IPmux-16.
Ethernet link redundancy to the network is supported when IPmux-8/16 is
equipped with two Ethernet modules. The unit supports one or two 1- or 4-port
Ethernet modules. The 4-port Ethernet modules include three user ports with L2
switch and rate limiter, and one 10/100BaseT or 10/100BaseFx uplink port. The 4-
port Ethernet modules perform VLAN-aware or transparent bridging.
IPmux-8/16 supports three operation modes for E1/T1: unframed, fractional E1/T1,
and fractional E1/T1 with CAS.
Multibundling can be performed for up to 31 bundles per E1 port and 24 bundles
per T1 port, for transport over the network. Both mesh and star topologies are
supported.
IPmux-8/16 allows an internal cross-connect of bundles between its E1 or T1 ports.
IPmux-8/16 supports VLAN tagging and priority labeling according to 802.1 p&Q.
The Type of Service (ToS) of outgoing TDMoIP packets is user-configurable.