Specifications

Quick Start Guide Installation and Operation Manual
2 Configuring IPmux-8/16 IPmux-8/16 Ver. 6.00
Configuring the IP Management Parameters
The host IP address and subnet mask must be configured via an ASCII terminal.

To configure the host IP parameters:
• From the Host IP menu (Configuration > General Configuration >
Management Configuration > Host Configuration), select an IP address and
subnet mask of the IPmux-8/16 hosts.

To add a network manager:
• From the Manager List menu (Configuration > General Configuration >
Management Configuration > Manager List), and enter IP parameters for the
network manager station.
Configuring TDM Interfaces at the Physical Level
The TDM interfaces (E1, T1, E3, T3, CT3) must be configured at the physical level
first.

To configure TDM interfaces at the physical level:
• From the Physical Layer Configuration menu (Configuration > Physical Layer
Configuration> Slot # 3/4 > E1, T1, E3, T3, or CT3, Physical Layer
Configuration), configure the necessary parameters of the appropriate TDM
interface.
Configuring Bundle Connections
The E1, T1 timeslots or unframed T1s of channelized T3 must be assigned to a
bundle. The bundle must be sent to the remote IP address and be connected to
one of the destination bundles.

To assign timeslots to a bundle:
• From Time Slots Configuration menu (Configuration > Time slots
Configuration), assign desired timeslots to a bundle.

To connect a bundle:
• From the Bundle Connection Configuration menu (Configuration > Bundle
connection configuration), set the following:
 Destination IP Address
 Destination Bundle.