Specifications

IPmux-8/16 Ver. 6.00 Configuring IPmux-8/16 1
Quick Start Guide
Installation of IPmux-8/16 should be carried out only by an experienced
technician. If you are familiar with IPmux-8/16, use this guide to prepare the units
for operation.
1. Installing IPmux-8/16
Connecting the Interface Cables
1. Connect the uplink(s) to the network Ethernet port(s). On 4-port Ethernet
modules networks ports designated as 1.
2. Connect the user LAN(s) to the RJ-45 connector(s) of the 4-port Ethernet
modules designated 2, 3 or 4.
3. Connect TDM interfaces to the appropriate connectors of the E1, T1, E3, T3,
or CT3 modules.
4. Connect the control terminal to the CONTROL DTE connector.
or
Connect a network management station to one of the LAN ports or CONTROL
ETH connector.
Connecting the Power Cable
1. Connect the power cable to the power connector(s) on the IPmux-8/16 rear
panel.
2. Set the POWER switch to the On position.
2. Configuring IPmux-8/16
Configure IPmux-8/16 to the desired operation mode via an ASCII terminal
connected to the CONTROL DTE port. Alternatively, you can manage IPmux-8/16
over Telnet, or via a network management station to one of the LAN ports or
CONTROL ETH connector.
Starting Terminal Session for a First Time

To start a terminal session:
1. Connect a terminal to the CONTROL connector of IPmux-8/16.
2. Turn on the control terminal PC and set its port parameters to 19.2 kbps,
8 bits/character, 1 stop bit, no parity. Set the terminal emulator to ANSI VT100
emulation (for optimal view of system menus).
3. Power IPmux-8/16 up and proceed with management session.