Specifications

Installation and Operation Manual Chapter 5 Configuring for a Typical Application
IPmux-8/16 Ver. 6.00 Configuring IPmux-16 5-5
Configuring E1 Parameters at the Physical Layer

To configure E1 parameters at the physical layer:
1. Display the TDM (E1) Configuration menu (Configuration > Physical Layer
Configuration> Slot # 3/4 > Channel 1–4/1–8 > E1 Physical Layer
Configuration), and configure the following parameters:
 Transmit Clock Source – Loopback
 Line Type – CRC4 disable
 Signaling Mode – CAS disable.
2. Leave all other parameters with their default values.
3. Save the changes.
Configuring Bundles

To assign timeslots to a bundle:
1. Display the Time Slots Configuration menu (Configuration > Time slots
Configuration), and select the following:
 Slot/Channel – slot and E1 channel contain the timeslots to be assigned to a
bundle
 Bundle number – 1
 Time slot Number – 1–10
 Time slot Current Status – SET.
2. Save the changes.
3. Press <Esc> to return to Configuration menu.
4. Display the Time Slots Configuration menu again and select the following:
 Slot/Channel – slot and E1 channel contain the timeslots to be assigned to a
bundle
 Bundle number – 2
 Time slot Number – 11–20
 Time slot Current Status – SET.
5. Save the changes.