Specifications

Installation and Operation Manual Chapter 5 Configuring for a Typical Application
IPmux-8/16 Ver. 6.00 Configuring IPmux-11 Units 5-3
The initial configuration of the IPmux-11 and the IPmux-16 needs to be done via
an ASCII terminal connected to the IPmux terminal control port. However, after
performing the initial configuration (host IP address, default gateway and a
manager list), you can manage the units using any of the following options:
• Manage IPmux-11 or IPmux-16 from any IP host using the Telnet protocol.
After establishing a Telnet session with the IPmux unit, the Telnet protocol
offers the same functionality as the supervisory terminal, enabling remote
access over IP networks.
• Manage IPmux-11 or IPmux-16 by means of SNMP-based network
management stations, e.g., the RADview TDMoIP Service Center network
management station offered by RAD.
5.2 Configuring IPmux-11 Units
This section explains how to configure IPmux-11 units. The configuration
procedure is similar for both units, except for defining different destination
bundles.
Configuring the IP Parameters

To configure the host IP parameters:
1. Display the Host IP menu (Configuration > System > Host IP), and configure
the IP address and mask of the host.
2. Save the changes.

To configure the manager list:
1. Display the Manager List menu (Configuration > System > Management >
Manager list), and enter IP parameters for the network manager station.
2. Save the changes.
Configuring E1 Parameters at the Physical Layer

To configure E1 parameters at the physical layer:
1. Display the TDM (E1) Configuration menu (Configuration > Physical layer >
TDM (E1) configuration), and configure the following parameters:
 Transmit clock source – Adaptive
 Line type – Framed G.704.
2. Leave all other parameters with their default values.
3. Save the changes.