Specifications

IPmux-8/16 Ver. 6.00 Overview 5-1
Chapter 5
Configuring for a Typical
Application
This chapter provides detailed instructions for setting up a typical application using
IPmux-11 and IPmux-16.
5.1 Overview
Application
The section provides detailed instructions for configuring two IPmux-11 units
opposite an IPmux-16 unit, in a point-to-multipoint application including
configuration via a supervisory terminal (see
Figure 5-1).
Figure 5-1. Two IPmux-11 Units Operating opposite IPmux-16
Guidelines for Configuring IPmux Units
Certain guidelines are relevant to this application. In general, there are four basic
configuration steps (described below) that need to be followed when deploying
any IPmux unit.
1. IP Configuration – Setting the device host IP address and the manager IP
address.
For IPmux-16 it is necessary to define three IP addresses:
• For out-of-band management traffic (optional)
• For TDMoIP traffic via Ethernet port 1
• For TDMoIP traffic via Ethernet port 2.
Note