Specifications

Installation and Operation Manual Chapter 4 Configuration
IPmux-8/16 Ver. 6.00 Configuring IPmux-8/16 for Operation 4-29
PROTECTION SWITCHING CONFIGURATION
1. Primary Bundle ID (0=None) 0
2. Secondary Bundle ID (0=None) 0
3. Redundancy Type 1:1
4. TDM Fail Time Disable
8. Local Fail Time (msec) 1 sec
9. Forced Connection Disable
A. Recovery Yes
B. Wait-To-Restore Time 0 sec
ESC. Exit N. Next
Select item from the menu.
Use <ESC>-key or keys <1> to <9> and <A> to <B>
Figure 4-16. Protection Switching Configuration Menu
Protection Switching Configuration Guidelines
This section provides examples for configuring bundle redundancy.
Configuring Bundle Redundancy for a Single Unit without TDM Protection
Figure 4-17 illustrates a bundle redundancy application (without TDM protection).
Figure 4-17. Bundle Redundancy without TDM Protection

To configure bundle redundancy (without TDM protection):
1. Define host IP and mask IP addresses for Ethernet module 1 and 2.
2. Configure the TDM ports at the physical layer.
3. Assign timeslots to the bundles:
 Framed mode:
1. Select a number for a bundle to be configured as a primary bundle.
2. Assign timeslots to the primary bundle.
3. Save the changes.
4. Select a number for a bundle to be configured as a secondary bundle.
The bundle must be within the allowed bundle range for the port.