Specifications

Chapter 4 Configuration Installation and Operation Manual
4-22 Configuring IPmux-24 for Operation IPmux-24 Ver. 1.5
 Mark (Code specified by the Mark Signaling Code parameter is sent)
 Space Mark (Space code is sent in the first 2.5 seconds, then mark
code is sent)
 Mark Space (Mark code is sent in the first 2.5 seconds, then space
code is sent)
 Mark Signaling Code: 0–f. For the framed MF or framed MF CRC4 line
types only
 Space Signaling Code: 0–f. For the framed MF or framed MF CRC4 line
types only
 Ethernet Network Type (Type of the Ethernet network which is used for
the pseudowire connection. Different network types are characterized by
different packet delay variation models. This parameter is relevant only
when the adaptive clock mode is selected.)
 WAN – Layer 3 network
 LAN – Layer 2 network.
4. Type S to save the changes.
Configuration>Physical layer>TDM (E1)
Channel ID (1)
Restoration time >(CCITT)
Signaling mode (CAS Disabled)
6. Administrative Status (Up)
7. Transmit clock source >(Adaptive)
8. Source clock quality >(Other/unknown)
9. Trail Mode (Termination)
10.Line type >(Framed G.704)
11.Line interface (LTU)
12.Idle code[0 - ff] ... (7E)
13.Send upon fail (OOS Code)
14.OOS Code[0 - ff] ... (FF)
15. Ethernet network type >(WAN)
>
Please select item <1 to 10>
ESC-prev.menu; !-main menu; &-exit 1 Mngr/s
Figure 4-20. Figure 4-21. TDM (E1) Menu
Configuring the E1 External Clock Interface Type
For the units with the E1 user interface it is necessary to define the external
clock interface type: balanced or unbalanced. When it is set to unbalanced,
connection to the external clock source must be performed via CBL-
RJ45/2BNC/E1/X adapter cable.