Specifications

Chapter 4 Configuration Installation and Operation Manual
4-16 Configuring IPmux-24 for Management IPmux-24 Ver. 1.5
 Shared Secret (The shared secret is a password used by RADIUS to
authenticate the client. IPmux-24 encrypts the user-password, if present;
using the secret it shares with the RADIUS server.): Any alphanumeric
string up to 16 characters
 Number of retries (The number of retries to be made when sending
request to the RADIUS server): 1–5
 Timeout (The maximum time IPmux-24 waits for a single request
response from the RADIUS server (in seconds). After this time the
request is retransmitted.): 1–60
 Authentication Port (The UDP port number to be used for the RADIUS
authentication application. Make sure to define the same value in the
RADIUS server.): any valid UDP port number
 Accounting Port (The UDP port number to be used for the RADIUS
accounting. Make sure to define the same value in the RADIUS server.):
any valid UDP port number.
Configuring Control Port Parameters
Configuration parameters of the IPmux-24 control port, except for the baud rate
are set at the factory and cannot be changed by the user (see
Figure 4-16 ).
These parameters have the following values:
• Data bits – 8
• Parity – None
• Stop bits – 1
• Flow control – None.
³ To select the baud rate:
1. From the System menu, select Control port.
The Control Port menu is displayed (see
Figure 4-16 ).
2. From the Control Port menu, select Baud rate, and configure baud rate of the
IPmux-24 terminal control port to the desired value (9600, 19200, 38400,
57600 or 11520 bps).
Configuration>System>Control port
Data bits (8)
Parity > (None)
Stop bits (1)
Flow control > (None)
1. Baud rate (bps) > (115200)
>
ESC-prev.menu; !-main menu; &-exit 1 Mngr/s
Figure 4-16. Control Port Menu